Rooster Weathervane

$349.00 $329.00
(You save $20.00)
Write a Review
Free Shipping
Rooster Weathervane

Standard Weathervane without locking pin

The Rooster Weathervane is sold with the following.

1. Weathervane mounting rod. Made from steel that has been powder coated black. Standard weathervane rods consist of two pieces. A 3/4" diameter 18" long bottom rod. With either a 3/8" or 1/2" diameter top spindle. You can upgrade this rod to stainless steel for harsh weather environments

2. Copper Spacer Balls 2 inch & 4 inch

3. Weathervane directionals. North, South, East, West. They are 18" long from letter to letter. Each Letter is 3" tall. 

4. 3/4" Ring to hold up bottom copper spacer ball

The NSEW, and copper spacer balls take up 10 inches of the 3/4" rod. You are left with 8 inches of rod left over below the large spacer ball to either go into one of our roof mounts or cupolas.

This weathervane is made from 24 GA 16 oz pure copper.

Figure Dimensions: 27" Long x 25" Tall 

Add 10" to the height for the copper balls and directionals.

If you have questions about any of the weathervane options please check out our weathervane options help page. It can be found by clicking on the link below.

Assembly instructions can be found by clicking on the link below.

1 Review Hide Reviews Show Reviews

  • 5
    Rooster Weathervane

    Posted by James on Dec 30th 2020

    The weathervane is beautiful , it looks so nice on our 120 year old barn about 50 feet high at the peak. My only issue is the bronze paint was peeling off of the lower ball and parts of the rooster. The copper was not prepared properly and the paint did not bond well. applied. Good thing is is so high, hard to notice. The directional part of the weather vane spins very well even though I was not able to make to balance it correctly. I wish the adjustable roof stand had a way to adjust the plumb ness after attaching it to the roof would be helpful. Overall it is easy to install and looks very nice.